Build Your Own Superfast Polyphonic Octaver Pedal with DT-FOG Module

Introduction to DT-FOG Module Unlike other polyphonic octaver pedals those have significant latency, DT-FOG module produce octave and sub-octave with almost imperceptible latency. The DT-FOG module processes transient and non-transient signal components separately. This separation enable the transient processor to have superfast latency as low as 1/100 seconds (10 milliseconds), and the non-transient processor to have a good frequency resolution […]

Read more

DIY Guitar Vocoder Pedal Using BWE-VO3 Module and GBPM-2 PCB

WARNING! As of August 30th 2023, BWE-VO3 module is discontinued (obsolete), replaced by DT-VO4 vocoder module. Refer to the following documents to build DT-VO4 Vocoder: DT-VO4 Vocoder Module User Manual DT-VO4 Application Note (BUILDING GUITAR VOCODER PEDAL USING DT-VO4 MODULE AND BGPM-2 PCB) Introduction BWE-VO3 is a vocoder effect module designed for guitar effect pedal application, based on digital simulation […]

Read more

ESP32 I2S-PDM Interface for Digital Guitar Pedal Application

The PDM (pulse-density modulation) has been widely used in the current technology of audio signal conversion (from analog to digital) because its simplicity while achieving high quality conversion. This technology is widely used in digital microphone, and it is basically a sigma delta modulator circuit which is used in many modern audio codec chip as well. It is an interesting […]

Read more

DIY Reverb Pedal Circuit: Spring-Hall Reverb with PT2399 IC

Introduction to Reverberation Before getting into the design of DIY reverb pedal circuit, lets see the concept of reverberation first. Real reverberation happens in a performance chamber when the walls and every object inside reflects the sound back and forth. As the sound bounces back and forth in three dimensional space, the reflections creates more and more complex pattern. The […]

Read more